Project
™
®
Item
Frymaster
Quantity
CSI Section 11400
Approval
Date
FPH55 and FPH55-2
Gas Fryers
Models
FPH55
FPH55-2
Standard Features
Options &
• Self-contained FootPrint® filter --
extends oil life, saves money
Accessories
Basket lifts
• Electronic ignition/infrared burners
-- no pilot to light -- saves time
• Open-pot design -- deep cold zone
--Easy to clean which helps reduce
carbon buildup ensuring better
tasting food
Multi-product computer
Casters (2 on back only)
Frypot cover
Sediment tray
Screen-type basket support
rack
--Deep cold zone traps sediment out
of cooking areas
Fish plate
Full size basket in lieu of twin
Quick disconnect
Back up controller
• Centerline, solid state 1° action sen-
sor/controller responds quickly to
cold foods placed in either basket
ensuring uniformly-cooked product
• Boil-out mode -- for easy cleaning
Shown with optional computer
Specifications
Single high efficiency fryers with FootPrint®
Filtration
infrared heat on a large heat transfer area for rapid recovery
to frying temperature, yielding more product with less fuel
consumption.
The FPH55 is a single, high efficiency (H55) gas fryer with a
FootPrint filter contained beneath it. For maximum overall
efficiency, the FPH55 combines high volume, fuel efficient
frying with convenient, labor-saving filtration.
The open-pot design has no hard-to-clean tubes, and can
be thoroughly cleaned by hand. The deep cold zone traps
crumbs and sediment from the frying area. These particles
are trapped in the cold zone where they do not carbonize,
contaminate shortening or cling to fried foods. The standard
rear flush feature moves sediment to the front drain valve
for easy and thorough removal. A Power Shower feature can
be substituted for the front flush feature at time of order
The FootPrint filter requires no additional floor or storage
space. This hands-off filtering system is enhanced to set
new standards for cost savings, safety, ease of operation and
dependability. The entire filtering operation is automatic
and takes three minutes to complete. FootPrint filtration
makes frequent filtering simple and safe, extending the life
of expensive shortening to reduce operating costs and yield
high-quality, good-tasting products.
Each side of the FPH55-2 (split pot) fryer operates on 40,000
BTU/hr. (10,076 kcal/hr.) (11.7 kW), has a maximum shorten-
ing capacity of 25 lbs. (12 liters*), and has a frying area of
6-1/2 x 15 inches (165 x 381 mm). This fryer has all of the
features and options of the FPH55 and gives the operator
the ability to cook different foods simultaneously.
This single FootPrint filtration system operates on 80,000
BTU/hr. (20,151 kCal/hr.) (23.4kW). The frying area is 14” x 15”
(356 x 381 mm), and the maximum shortening capacity is 50
lbs. (25 liters*). It features a solid state controller that assures
product consistency and a centerline temperature sensor
for quick sensing of temperature drops caused by cold food
placed in the cooking area. Infrared power burners direct
*Liter conversions are for solid shortening @ 70°F.
8700 Line Avenue 71106
P. O. Box 51000 71135-1000
Shreveport, LA
Tel: 318-865-1711
Tel: 1-800-221-4583
Fax: 318-868-5987
Bulletin No. 818-0184 10/06
E-mail: [email protected]
Download from Www.Somanuals.com. All Manuals Search And Download.
™
®
Frymaster
14.00
[356]
10.25
[260]
GAS LINE
27.09
[688]
TOP VIEW
35.69
[907]
15.63
[397]
31.58
[802]
6 ft. (1.8m)
CORD SET 120V
PROVIDED
45.30
[1151]
35.50
[902]
DRAIN
HEIGHT
21.00
[533]
13.50
[343]
FILTER DRAIN
6.50
[165]
6.00
FRONT VIEW
[152]
SIDE VIEW
GAS LINE
diMenSiOnS
moDel ShortenIng
overAll SIze (cm)
DrAIn
net
ShIPPIng InformAtIon
no.
CAPACIty
heIght weIght
heIght
wIDth
length
weIght ClASS Cu. ft.
DImenSIonS
FPH55
and
FPH55-2
50 lbs.
(25 liters)
45.30”
15.63”
35.69”
13.50”
235 lbs.
265 lbs. 85 31.95
H
W
L
(1151 mm) (397 mm) (907 mm) (343 mm) (107 kg) (121 kg)
47”
25”
47”
(1194 mm) (635 mm) (1194 mm)
POwer requireMentS
nAturAl gAS
nOteS
lP gAS
eleCtrICAl
eXPort
Supply Voltage 120V 60Hz -- Control Voltage 24V 60 Hz.
120 VAC 5 ft. (1.5 m) grounded cord set provided.
Recommended minimum store manifold pressure to be
6”W.C. for NAT Gas, and 11”W.C. for L.P. Check plumb-
ing codes for proper supply line sizing to attain burner
manifold pressure of 3.0”W.C. natural or 8.25”W.C. L.P.
Incoming supply line should be 1-1/2”.
80,000 BTU/hr. input
(20,151 kCal/hr.)
(23.4 kW)
80,000 BTU/hr. input
(20,151 kCal/hr.)
(23.4 kW)
120V 60 Hz
Supply 9 Amps
220V/230V/240V
50 Hz.
HOw tO SPeciFy
All units whether single or in battery require 1” connec-
tion. Should flexible gas line be used, it must be AGA
approved, commercial type and at least 1” I.D.
FPH55
High efficiency gas fryer with FootPrint Filtration, solid
state controller
FPH55C High efficiency gas fryer with FootPrint Filtration and
Computer Magic
cLeArAnce inFOrMAtiOn
FPH55-2 Split pot with same features as full pot plus dual controls
to operate each pot independently
A minimum of 24” (610 mm) should be provided at the
front of the unit for servicing and proper operation, and
6” (152 mm) between the sides and rear of the fryer to
any combustible material.
SD
SC
SE
Stainless steel frypot and door -- enamel cabinet
Stainless steel frypot, door and cabinet
Stainless steel frypot, door and cabinet ends
8700 Line Avenue 71106
P. O. Box 51000 71135-1000
Shreveport, LA
Tel: 318-865-1711
Tel: 1-800-221-4583
Fax: 318-868-5987
Bulletin No. 818-0184 10/06
Litho in U.S.A. ©Frymaster, L.L.C.
E-mail: [email protected]
We reserve the right to change specifications appearing in this bulletin without incurring any obligation for equipment previously or subsequently sold.
Download from Www.Somanuals.com. All Manuals Search And Download.
|